TL3474IPWRG4 Overview
In the package, you will find a TSSOP-case to contain the op amp ic. The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. A Tape and Reel case is used for delivering the op amp. During the past two weeks, there have been close to 14 terminations. A total of 14 pins are located on this board. This linear amplifier should be powered by an 15V battery. The op amp ic has an array of 14 pins on it. Op amp rates 10mV as input offset voltage. Using an 3.5mA supply current, this operational amplifier ics can be operated. You should keep the voltage gain at 100dB for the time being. To operate this buffer amplifier, the temperature must not be lower than -40°C. A temperature greater than 105°C should not be used for the operation of buffer amplifier. 4 elements make up the design of this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 18V. The linear amplifier is packaged by using a TR axis. This electric component can work from a voltage of under 36V as far as supply voltage is concerned. A voltage of 4V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 18V volts when you conduct this part.
TL3474IPWRG4 Features
14 Pins
supply voltage of 15V
100dB voltage gain
TL3474IPWRG4 Applications
There are a lot of Texas Instruments
TL3474IPWRG4 Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
