TL3472IDRG4 Overview
A D case is used to package the op amp. OPERATIONAL AMPLIFIER-type instrumentation amplifiers are used in this application. The case in which buffer amplifier is delivered is called a Tape & Reel case. It is estimated that there will be 8 terminations in the next few months. There are a total of 8 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 15V volts. It should be noted that this op amp is a type of Operational Amplifier device. There are 8 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 1mV. An 3.5mA volt supply current is needed for this linear amplifier to operate. There should be no change in the voltage gain. There are 2 channels on the operational amplifiers. In order for op amp to function properly, the temperature should not be lower than -40°C degrees Celsius. Instrumentation amplifier should only be used at temperatures up to 105°C. The operating supply voltage of the buffer op amp is rated at 18V. I would like to point out that this electrical component is capable of working from a voltage below 36V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 4V at all times. The dual supply voltage of 18V should be used for the conduct of this electronic component.
TL3472IDRG4 Features
8 Pins
supply voltage of 15V
100dB voltage gain
TL3472IDRG4 Applications
There are a lot of Texas Instruments
TL3472IDRG4 Instrumentational OP Amps applications.
- Addition operation circuits
- Subtraction operation circuits
- single/dual op amp sum and difference circuits
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
