TL3414AIDE4 Overview
In the package, you will find a D-case to contain the op amp ic. The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. This linear amplifier should be powered by an 5V battery. The op amp ic has an array of 8 pins on it. Op amp rates 2mV as input offset voltage. Using an 4mA supply current, this operational amplifier ics can be operated. You should keep the voltage gain at 100dB for the time being. On the buffer amps, there are 2 channels that can be used. To operate this buffer amplifier, the temperature must not be lower than -40°C. A temperature greater than 85°C should not be used for the operation of buffer amplifier. The operating supply voltage of the buffer op amp is rated at 7.5V. The linear amplifier is packaged by using a TUBE axis. This electric component can work from a voltage of under 15V as far as supply voltage is concerned. A voltage of 3V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 7.5V volts when you conduct this part.
TL3414AIDE4 Features
8 Pins
supply voltage of 5V
100dB voltage gain
TL3414AIDE4 Applications
There are a lot of Texas Instruments
TL3414AIDE4 Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
