THS4082CDRG4 Overview
In the package, you will find a SOIC-case to contain the op amp ic. A Tape and Reel case is used for delivering the op amp. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. The op amp ic has an array of 8 pins on it. Op amp rates 7mV as input offset voltage. Using an 3.4mA supply current, this operational amplifier ics can be operated. You should keep the voltage gain at 84.08dB for the time being. On the buffer amps, there are 1 channels that can be used. To operate this buffer amplifier, the temperature must not be lower than -40°C. A temperature greater than 85°C should not be used for the operation of buffer amplifier. 2 elements make up the design of this buffer amplifier. This electric component can work from a voltage of under 30V as far as supply voltage is concerned. A voltage of 10V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 16.5V volts when you conduct this part. Using the VIDEO AMPLIFIER column, it is possible to sort by the consumer IC type of the electronic ic chip. Refer to this op amp ic's additional benefit: IT CAN ALSO OPERATE WITH 10V TO 30V SINGLE SUPPLY.
THS4082CDRG4 Features
8 Pins
84.08dB voltage gain
THS4082CDRG4 Applications
There are a lot of Texas Instruments
THS4082CDRG4 Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
