THS4052CDR Overview
Op amp is packaged in 8-SOIC (0.154, 3.90mm Width) case. A Voltage Feedback-type buffer amplifier is shown here. The case in which buffer amplifier is delivered is called a Tape & Reel (TR) case. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are attached to buffer op amp. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. To be specific, this instrumentation amplifier is a type of Operational Amplifier. 8 pins are included on the operational amplifiers. The input offset voltage is 10mV. The mounting type that is recommended for this electrical part is Surface Mount. In terms of operating temperatures, this buffer amplifier works very well at a temperature of around 0°C~70°C . As long as the supply current of the chip does not exceed 8.5mA, this op amp ic can operate. It is recommended to keep the voltage gain at 75.56dB at all times. There are a total of 2 elements in this linear amplifier. A TR-shaped amplifier is used to pack the buffer amps.
THS4052CDR Features
8 Pins
supply voltage of 15V
75.56dB voltage gain
THS4052CDR Applications
There are a lot of Texas Instruments THS4052CDR Instrumentational OP Amps applications.
- Band-stop filter
- High/low-pass filter circuit
- Test equipment
- Strain gauges
- High speed sample
- Home audio systems
- Communication device
- High input resistance broadband
- Automotive sensors
- Signal filtering
