THS3112IDDARG3 Overview
A SOP case is used to package the op amp. The case in which buffer amplifier is delivered is called a Tape and Reel case. It is estimated that there will be 8 terminations in the next few months. There are a total of 8 pins on this op amp. There are 8 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 3mV. An 4.9mA volt supply current is needed for this linear amplifier to operate. There are 1 channels on the operational amplifiers. In order for op amp to function properly, the temperature should not be lower than -40°C degrees Celsius. Instrumentation amplifier should only be used at temperatures up to 85°C. There are a total of 2 elements in this linear amplifier. I would like to point out that this electrical component is capable of working from a voltage below 30V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 10V at all times. The dual supply voltage of 15V should be used for the conduct of this electronic component. Sorting based on consumer IC type can be done by using VIDEO AMPLIFIER. I would like to draw your attention to the following extra benefit of this buffer amplifier: ALSO OPERATES WITH 10 TO 30V SINGLE SUPPLY.
THS3112IDDARG3 Features
8 Pins
THS3112IDDARG3 Applications
There are a lot of Texas Instruments
THS3112IDDARG3 Instrumentational OP Amps applications.
- Addition operation circuits
- Subtraction operation circuits
- single/dual op amp sum and difference circuits
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
