THS3091DR Overview
Packaging for the buffer amplifier is in the form of a 8-SOIC (0.154, 3.90mm Width) case. Op amps are Current Feedback types of amplifier on the chip. A Tape & Reel (TR) case is used to deliver the buffer op amp. A total of 8 terminations have been reported in the past few weeks. A total of 8 pins are located on this board. I would like to remind you that this buffer op amp should be powered by an 15V battery. A type of Operational Amplifier op amp ic can be identified by the fact that this is a type of Operational Amplifier device. An 8-pin op amp ic is included in the package. As far as the input offset voltage is concerned, linear amplifier rates at 900μV. For this electrical component, Surface Mount is the recommended mounting type. According to the manufacturer, this buffer op amp works well at -40°C~85°C , which is a good operating temperature. As long as the supply current of the chip does not exceed 9.5mA, this op amp ic can operate. As a whole, there are 1 elements that make up this buffer amplifier. This linear amplifier pack is based on the TR axis.
THS3091DR Features
8 Pins
supply voltage of 15V
THS3091DR Applications
There are a lot of Texas Instruments THS3091DR Instrumentational OP Amps applications.
- Portable electronic products powered by batteries
- Proportional operation circuits
- Comparator
- Weak signal detection
- Displayers for aircraft and air transportation control systems
- Oscilloscopes
- Vehicle electronics
- Video amplifiers
- Video data acquisition
- Laptop
