SN74LV574ADW Overview
In the form of 20-SOIC (0.295, 7.50mm Width), it has been packaged. It is included in the package Tube. T flip flop uses Tri-State, Non-Invertedas its output configuration. Positive Edgeis the trigger it is configured with. There is an electric part mounted in the way of Surface Mount. Powered by a 2V~5.5Vvolt supply, it operates as follows. In the operating environment, the temperature is -40°C~85°C TA. This D latch has the type D-Type. FPGAs belonging to the 74LVseries contain this type of chip. Its output frequency should not exceed 175MHz Hz. The element count is 1 . It consumes 20μA of quiescent A total of 20 terminations have been made. JK flip flop belongs to 74LV574 family. A voltage of 2.5V is used to power it. A JK flip flop with a 1.8pFfarad input capacitance is used here. It is a member of the LV/LV-A/LVX/Hfamily of D flip flop. There is an electronic component mounted in the way of Surface Mount. There are 20pins on it. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. It is included in FF/Latches. Flip flops designed with 8bits are used in this part. There is a 5.5Vmaximum supply voltage (Vsup). For normal operation, the supply voltage (Vsup) should be kept above 2V. There are 2 ports embedded in the flip flops. The output current of 16mA makes it feature maximum design flexibility. It is reported that there are 3 input lines. A total of 8 channels are available.
SN74LV574ADW Features
Tube package
74LV series
20 pins
8 Bits
SN74LV574ADW Applications
There are a lot of Texas Instruments SN74LV574ADW Flip Flops applications.
- High Performance Logic for test systems
- ESCC
- Convert a momentary switch to a toggle switch
- Parallel data storage
- Clock pulse
- Storage registers
- Frequency Dividers
- Control circuits
- Bus hold
- Frequency division
