SN74LV175APWR Overview
The flip flop is packaged in a case of 16-TSSOP (0.173, 4.40mm Width). A package named Cut Tape (CT)includes it. T flip flop uses Differentialas the output. This trigger is configured to use Positive Edge. This electronic part is mounted in the way of Surface Mount. A voltage of 2V~5.5Vis required for its operation. -40°C~85°C TAis the operating temperature. Logic flip flops of this type are classified as D-Type. It is a type of FPGA belonging to the 74LV series. A frequency of 165MHzshould not be exceeded by its output. In total, it contains 1 elements. As a result, it consumes 20μA quiescent current. It has been determined that there have been 16 terminations. The 74LV175family includes it. A voltage of 2.5V is used as the power supply for this D latch. Its input capacitance is 1.4pF farads. The electronic device belongs to the LV/LV-A/LVX/Hfamily. A part of the electronic system is mounted in the way of Surface Mount. This board has 16 pins. The clock edge trigger type for this device is Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. There are 4bits in this flip flop. It reaches 5.5Vwhen the supply voltage is maximal (Vsup). If you want to maintain normal operation, you should keep the supply voltage (Vsup) above 2V. Its superior flexibility is attributed to its use of 4 circuits. As a result of its reliability, this D flip flop is ideally suited for TR. The D latch runs on a voltage of 3.3V volts. With an output current of 12mA, this device offers maximum design flexibility. In order to operate, the chip has 2 output lines.
SN74LV175APWR Features
Cut Tape (CT) package
74LV series
16 pins
4 Bits
3.3V power supplies
SN74LV175APWR Applications
There are a lot of Texas Instruments SN74LV175APWR Flip Flops applications.
- Latch
- Instrumentation
- Buffered Clock
- Common Clocks
- Dynamic threshold performance
- Functionally equivalent to the MC10/100EL29
- Single Up Count-Control Line
- Bounce elimination switch
- Storage Registers
- Asynchronous counter
