SN74LS173ANSRG4 Overview
It is packaged in the way of 16-SOIC (0.209, 5.30mm Width). As part of the package Tape & Reel (TR), it is embedded. In the configuration, Tri-State, Non-Invertedis used as the output. JK flip flop uses Positive Edgeas the trigger. There is an electric part mounted in the way of Surface Mount. A voltage of 4.75V~5.25Vis used as the supply voltage. The operating temperature is 0°C~70°C TA. D-Typedescribes this flip flop. JK flip flop belongs to the 74LSseries of FPGAs. This D flip flop should not have a frequency greater than 50MHz. In total, it contains 1 elements. It consumes 24mA of quiescent A total of 16 terminations have been made. You can search similar parts based on 74LS173. A voltage of 5V is used to power it. A device of this type belongs to the family of LS. There is an electronic part mounted in the way of Surface Mount. A total of 16pins are provided on this board. This device's clock edge trigger type is Positive Edge. This device is part of the FF/Latchesbase part number family. The design is based on 4bits. In this case, the maximum supply voltage (Vsup) reaches 5.25V. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. It runs on 5Vvolts of power. Featuring the maximum design flexibility, it has an output current of 24mA . To operate, the chip has a total of 4 output lines.
SN74LS173ANSRG4 Features
Tape & Reel (TR) package
74LS series
16 pins
4 Bits
5V power supplies
SN74LS173ANSRG4 Applications
There are a lot of Texas Instruments SN74LS173ANSRG4 Flip Flops applications.
- Power down protection
- CMOS Process
- Data storage
- Clock pulse
- Pattern generators
- Data Synchronizers
- Patented noise
- Shift Registers
- Functionally equivalent to the MC10/100EL29
- Load Control
