SN74LS173AD Overview
The flip flop is packaged in a case of 16-SOIC (0.154, 3.90mm Width). A package named Tubeincludes it. T flip flop uses Tri-State, Non-Invertedas its output configuration. In the configuration of the trigger, Positive Edgeis used. There is an electric part mounted in the way of Surface Mount. A voltage of 4.75V~5.25Vis required for its operation. Temperature is set to 0°C~70°C TA. It is an electronic flip flop with the type D-Type. In FPGA terms, D flip flop is a type of 74LSseries FPGA. Its output frequency should not exceed 50MHz Hz. There are 1 elements in it. The number of terminations is 16. It is a member of the 74LS173 family. The D flip flop is powered by a voltage of 5V . It belongs to the family of electronic devices known as LS. A part of the electronic system is mounted in the way of Surface Mount. Basically, it is designed with a set of 16 pins. This device has Positive Edgeas its clock edge trigger type. It is included in FF/Latches. It runs on 5Vvolts of power. In order to achieve high efficiency, the supply voltage should be maintained at 5V. It offers maximum design flexibility with its output current of 24mA. There are 2 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply. Furthermore, it has WITH HOLD MODE; WITH DUAL OUTPUT ENABLE; DISABLE TIME CL = 5PFas a characteristic.
SN74LS173AD Features
Tube package
74LS series
16 pins
5V power supplies
SN74LS173AD Applications
There are a lot of Texas Instruments SN74LS173AD Flip Flops applications.
- Set-reset capability
- Computing
- Data transfer
- Communications
- ESCC
- Safety Clamp
- Latch
- Memory
- Divide a clock signal by 2 or 4
- Registers
