SN74ALS564BDW Overview
The flip flop is packaged in a case of 20-SOIC (0.295, 7.50mm Width). It is contained within the Tubepackage. As configured, the output uses Tri-State, Inverted. In the configuration of the trigger, Positive Edgeis used. The electronic part is mounted in the way of Surface Mount. A supply voltage of 4.5V~5.5V is required for operation. A temperature of 0°C~70°C TAis considered to be the operating temperature. This electronic flip flop is of type D-Type. It is a type of FPGA belonging to the 74ALS series. There should be no greater frequency than 30MHzon its output. There are 1 elements in it. As a result, it consumes 18mA quiescent current and is not affected by external forces. 20terminations have occurred. D latch belongs to the 74ALS564 family. Power is supplied from a voltage of 5V volts. This D flip flop belongs to the family of ALS. The electronic part is mounted in the way of Surface Mount. The 20pins are designed into the board. A Positive Edgeclock edge trigger is used in this device. It is included in FF/Latches. This flip flop is designed with 8 Bits. Due to its superior flexibility, it uses 8 circuits. The D latch runs on a voltage of 5V volts. A total of 2ports are embedded in the D flip flop. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. This T flip flop features a maximum design flexibility due to its output current of 24mA. It has 3lines.
SN74ALS564BDW Features
Tube package
74ALS series
20 pins
8 Bits
5V power supplies
SN74ALS564BDW Applications
There are a lot of Texas Instruments SN74ALS564BDW Flip Flops applications.
- Reduced system switching noise
- EMI reduction circuitry
- Consumer
- Computers
- 2 – Bit synchronous counter
- Control circuits
- Matched Rise and Fall
- Count Modes
- ESCC
- Patented noise
