SN74ALS374ANSR Overview
The item is packaged in 20-SOIC (0.209, 5.30mm Width)cases. D flip flop is embedded in the Tape & Reel (TR) package. This output is configured with Tri-State, Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis required for its operation. A temperature of 0°C~70°C TAis used in the operation. This electronic flip flop is of type D-Type. It is a type of FPGA belonging to the 74ALS series. There should be no greater frequency than 35MHzon its output. The list contains 1 elements. 20terminations have occurred. D latch belongs to the 74ALS374 family. An input voltage of 5Vpowers the D latch. ALSis the family of this D flip flop. It is mounted in the way of Surface Mount. This board is designed with 20pins on it. The clock edge trigger type for this device is Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. An electronic part designed with 8bits is used in this application. The superior flexibility of this circuit is achieved by using 8 circuits. Considering its reliability, this T flip flop is well suited for TR. It runs on 5Vvolts of power. This flip flop has a total of 2ports. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. With a current output of 24mA , it offers maximum design flexibility. A total of 3input lines have been provided. This D latch consumes 19mA quiescent current at all.
SN74ALS374ANSR Features
Tape & Reel (TR) package
74ALS series
20 pins
8 Bits
5V power supplies
SN74ALS374ANSR Applications
There are a lot of Texas Instruments SN74ALS374ANSR Flip Flops applications.
- Registers
- Storage registers
- Buffered Clock
- Asynchronous counter
- Data transfer
- Frequency Dividers
- Reduced system switching noise
- Synchronous counter
- Frequency division
- CMOS Process
