SN74AHCT16374DL Overview
The flip flop is packaged in 48-BSSOP (0.295, 7.50mm Width). Package Tubeembeds it. In the configuration, Tri-State, Non-Invertedis used as the output. It is configured with a trigger that uses Positive Edge. Surface Mountis positioned in the way of this electronic part. Powered by a 4.5V~5.5Vvolt supply, it operates as follows. In the operating environment, the temperature is -40°C~85°C TA. This logic flip flop is classified as type D-Type. This type of FPGA is a part of the 74AHCT series. You should not exceed 130MHzin its output frequency. The element count is 2 . This process consumes 4μA quiescents. There have been 48 terminations. If you search by 74AHCT16374, you will find similar parts. A voltage of 5V provides power to the D latch. The input capacitance of this T flip flop is 2.5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. AHCT/VHCT/VTis the family of this D flip flop. There is an electronic part that is mounted in the way of Surface Mount. 48pins are included in its design. A Positive Edgeclock edge trigger is used in this device. There is a base part number FF/Latchesfor the RS flip flops. The design is based on 16bits. It operates from 5V power supplies. This flip flop has a total of 2ports. For high efficiency, the supply voltage should be set to 5V. In addition to its maximum design flexibility, the output current of the T flip flop is 8mA. The JK flip flop is with 3 output lines to operate.
SN74AHCT16374DL Features
Tube package
74AHCT series
48 pins
16 Bits
5V power supplies
SN74AHCT16374DL Applications
There are a lot of Texas Instruments SN74AHCT16374DL Flip Flops applications.
- Frequency Dividers
- Cold spare funcion
- Count Modes
- Frequency Divider circuits
- Clock pulse
- Digital electronics systems
- Circuit Design
- Single Down Count-Control Line
- Divide a clock signal by 2 or 4
- QML qualified product
