SN74ACT534DW Overview
20-SOIC (0.295, 7.50mm Width)is the way it is packaged. Package Tubeembeds it. As configured, the output uses Tri-State, Inverted. JK flip flop uses Positive Edgeas the trigger. There is an electric part mounted in the way of Surface Mount. It operates with a supply voltage of 4.5V~5.5V. Temperature is set to -40°C~85°C TA. It belongs to the type D-Typeof flip flops. In this case, it is a type of FPGA belonging to the 74ACT series. Its output frequency should not exceed 100MHz. D latch consists of 1 elements. There is a consumption of 4μAof quiescent energy. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. The object belongs to the 74ACT534 family. The D flip flop is powered by a voltage of 5V . A JK flip flop with a 4.5pFfarad input capacitance is used here. It is a member of the ACTfamily of D flip flop. This electronic part is mounted in the way of Surface Mount. The 20pins are designed into the board. This device exhibits a clock edge trigger type of Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. There are 8bits in its design. Its flexibility is enhanced by 8 circuits. The power supply is 5V. This D flip flop is equipped with 0 ports. Optimal efficiency requires a supply voltage of 5V. This T flip flop features a maximum design flexibility due to its output current of 24mA. A total of 3input lines have been provided.
SN74ACT534DW Features
Tube package
74ACT series
20 pins
8 Bits
5V power supplies
SN74ACT534DW Applications
There are a lot of Texas Instruments SN74ACT534DW Flip Flops applications.
- ESCC
- Storage registers
- QML qualified product
- Event Detectors
- ATE
- Data transfer
- Shift Registers
- Bus hold
- 2 – Bit synchronous counter
- Memory
