SN74ABT377ANSR Overview
It is embeded in 20-SOIC (0.209, 5.30mm Width) case. As part of the package Tape & Reel (TR), it is embedded. It is configured with Non-Invertedas an output. It is configured with a trigger that uses a value of Positive Edge. It is mounted in the way of Surface Mount. The JK flip flop operates at 4.5V~5.5Vvolts. Currently, the operating temperature is -40°C~85°C TA. It is an electronic flip flop with the type D-Type. It is a type of FPGA belonging to the 74ABT series. Its output frequency should not exceed 150MHz Hz. A total of 1elements are contained within it. It consumes 250μA of quiescent In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. The object belongs to the 74ABT377 family. The D flip flop is powered by a voltage of 5V . Input capacitance of this device is 3.5pF farads. Devices in the ABTfamily are electronic devices. This electronic part is mounted in the way of Surface Mount. This board is designed with 20pins on it. This device exhibits a clock edge trigger type of Positive Edge. This part is included in FF/Latches. Flip flops designed with 8bits are used in this part. Using 8 circuits, it is highly flexible. Considering its reliability, this T flip flop is well suited for TR. It runs on 5Vvolts of power. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. In addition, you can refer to the additinal WITH HOLD MODE of the D latch.
SN74ABT377ANSR Features
Tape & Reel (TR) package
74ABT series
20 pins
8 Bits
5V power supplies
SN74ABT377ANSR Applications
There are a lot of Texas Instruments SN74ABT377ANSR Flip Flops applications.
- Data Synchronizers
- Synchronous counter
- Communications
- Storage registers
- Digital electronics systems
- Cold spare funcion
- Consumer
- ESCC
- Storage Registers
- Power down protection
