SN74ABT377ADWE4 Overview
The flip flop is packaged in SOIC. As configured, the output uses TTL. In total, there are 1 elements. Currently, there are 20 terminations. The D flip flop is powered by a voltage of 5V . Devices in the ABTfamily are electronic devices. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 20pins on it. This device has Positive Edgeas its clock edge trigger type. There is a base part number FF/Latchesfor the RS flip flops. As a result of its reliable performance, this T flip flop is suitable for TUBE. It runs on 5Vvolts of power. If high efficiency is desired, the supply voltage should be kept at 5V. Additionally, you may refer to the D latch's additional WITH HOLD MODE. -32mA is set as the high level output current. In the low level output current setting, 64mAis used. It is recommended that the operating temperature be below 85°C. Ideally, the operating temperature should be higher than -40°C. A minimum supply voltage of 4.5V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 5.5V. It is possible to achieve 150MHz frequencies. It uses a logic IC with a D FLIP-FLOP value. A total of 1 functions are available on the T flip flop. There are 20 pins on the D latch. This flip flop features a maximum design flexibility due to its output current of 64mA.
SN74ABT377ADWE4 Features
20 pins
5V power supplies
1 Functions
20 pin count
SN74ABT377ADWE4 Applications
There are a lot of Texas Instruments
SN74ABT377ADWE4 Flip Flops applications.
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
