SN74ABT273DBR Overview
In the form of 20-SSOP (0.209, 5.30mm Width), it has been packaged. It is contained within the Cut Tape (CT)package. It is configured with Non-Invertedas an output. It is configured with the trigger Positive Edge. There is an electronic component mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis required for its operation. A temperature of -40°C~85°C TAis considered to be the operating temperature. It belongs to the type D-Typeof flip flops. The 74ABTseries comprises this type of FPGA. You should not exceed 150MHzin its output frequency. In total, there are 1 elements. T flip flop consumes 400μA quiescent energy. The number of terminations is 20. It is a member of the 74ABT273 family. A voltage of 5V is used as the power supply for this D latch. A JK flip flop with a 7pFfarad input capacitance is used here. This D flip flop belongs to the family of ABT. It is mounted by the way of Surface Mount. 20pins are included in its design. This device exhibits a clock edge trigger type of Positive Edge. This RS flip flops is a part number FF/Latches. This flip flop is designed with 8 Bits. Its flexibility is enhanced by 8 circuits. As a result of its reliable performance, this T flip flop is suitable for TR. A total of 5V power supplies are needed to run it. High efficiency requires the supply voltage to be maintained at 5V. It consumes a total of 30mA quiescent current at any given time.
SN74ABT273DBR Features
Cut Tape (CT) package
74ABT series
20 pins
8 Bits
5V power supplies
SN74ABT273DBR Applications
There are a lot of Texas Instruments SN74ABT273DBR Flip Flops applications.
- Convert a momentary switch to a toggle switch
- ESD protection
- Power down protection
- Communications
- Data storage
- Buffered Clock
- Guaranteed simultaneous switching noise level
- Event Detectors
- Control circuits
- Frequency Dividers
