SN10501DGNG4 Overview
In the package, you will find a HTSSOP EP-case to contain the op amp ic. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. This particular linear amplifier is a type of Audio/Video Amplifiers device, to be precise. The op amp ic has an array of 8 pins on it. Op amp rates 25mV as input offset voltage. Using an 14mA supply current, this operational amplifier ics can be operated. You should keep the voltage gain at 100dB for the time being. On the buffer amps, there are 1 channels that can be used. To operate this buffer amplifier, the temperature must not be lower than -40°C. A temperature greater than 85°C should not be used for the operation of buffer amplifier. 1 elements make up the design of this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 5V. This electric component can work from a voltage of under 16V as far as supply voltage is concerned. A voltage of 2.7V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 9V volts when you conduct this part. Using the VIDEO AMPLIFIER column, it is possible to sort by the consumer IC type of the electronic ic chip.
SN10501DGNG4 Features
8 Pins
100dB voltage gain
SN10501DGNG4 Applications
There are a lot of Texas Instruments
SN10501DGNG4 Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
