RC4558IPE4 Overview
Packaged in a PDIP case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 15V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 500μV for this buffer op amp. As long as the supply current of the chip does not exceed 2.5mA, this op amp ic can operate. Keeping the voltage gain at 109.54dB is the best course of action. As far as the device is concerned, buffer amplifier has 2 channels. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. No temperature greater than 85°C should be used. The operating supply voltage of the buffer op amp is rated at 15V. For packing the buffer amplifier, the TUBE-axis is adopted. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 15V volts.
RC4558IPE4 Features
8 Pins
supply voltage of 15V
109.54dB voltage gain
RC4558IPE4 Applications
There are a lot of Texas Instruments
RC4558IPE4 Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
