OPA847IDR Overview
A 8-SOIC (0.154, 3.90mm Width) case is used to package the op amp. There are two types of operational amplifiers in this circuit. The op amp is delivered to you in a Tape & Reel (TR) case. A total of 8 terminations have been reported in the past few weeks. A total of 8 pins are attached to buffer op amp. I would like to remind you that this buffer op amp should be powered by an 5V battery. It should be noted that this op amp is a type of Operational Amplifier device. The op amp ic has an array of 8 pins on it. In terms of input offset voltage, operational amplifier rates 500μV. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. The buffer amplifier functions well at -40°C~85°C as far as operating temperature is concerned. This op amp can operate from a supply current at 18.1mA. You should keep the voltage gain at 98dB for the time being. The linear amplifier consists of 1 different elements in total. For the packing of the instrumentation amplifier, TR is adopted.
OPA847IDR Features
8 Pins
supply voltage of 5V
98dB voltage gain
OPA847IDR Applications
There are a lot of Texas Instruments OPA847IDR Instrumentational OP Amps applications.
- Proportional counter tubes
- Television
- RF cable systems
- High speed sample
- Division circuits
- Power generator
- Voltage regulation circuit
- High/low-pass filter circuit
- High input resistance broadband
- Power control
