OPA842IDR Overview
There is a 8-SOIC (0.154, 3.90mm Width) case in which the instrumentation amplifier is packaged. Op amps are Voltage Feedback types of amplifier on the chip. There is a Tape & Reel (TR) case that is delivered with the instrumentation amplifiers. During the past two weeks, there have been close to 8 terminations. The pins on this board total to 8 in total. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. To be specific, this instrumentation amplifier is a type of Operational Amplifier. An 8-pin op amp ic is included in the package. There is an input offset voltage of 1.2mV for this buffer op amp. This electronic part is recommended for mounting type Surface Mount. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about -40°C~85°C . It is possible to operate this buffer amplifier from a supply current of 20.2mA . There should be no change in the voltage gain at 110dB. There are a total of 1 elements in this linear amplifier. The operating supply voltage of instrumentation amplifier is rated 12V voltage. A TR-shaped amplifier is used to pack the buffer amps.
OPA842IDR Features
8 Pins
supply voltage of 5V
110dB voltage gain
OPA842IDR Applications
There are a lot of Texas Instruments OPA842IDR Instrumentational OP Amps applications.
- Tablets
- Radar
- Vehicle electronics
- Signal operation
- Power control
- earphone
- Band-stop filter
- Image computer boards
- Medical imaging
- Video data acquisition
