OPA501AM Overview
There is a TO-3-8 case in which the instrumentation amplifier is packaged. Power-type instrumentation amplifiers are used in this application. As far as the packaging is concerned, buffer op amp is delivered in a Tube case. During the past two weeks, there have been close to 8 terminations. A total of 2 pins are located on this board. I would like to remind you that this buffer op amp should be powered by an 28V battery. Instrumentation amplifier is a part of Operational Amplifier. In terms of input offset voltage, operational amplifier rates 5mV. The mounting type that is recommended for this electrical part is Through Hole. In terms of operating temperature, this instrumentation amplifier is well suited to a temperature range of -25°C~85°C. An 2.6mA volt supply current is needed for this linear amplifier to operate. 115dB should be the voltage gain. On this instrumentation amplifier, there are 1 circuits that are connected together. The operating supply voltage of the buffer op amp is rated at 36V.
OPA501AM Features
2 Pins
supply voltage of 28V
115dB voltage gain
OPA501AM Applications
There are a lot of Texas Instruments OPA501AM Instrumentational OP Amps applications.
- Measurements of Wheatstone bridge
- Communication
- Test equipment
- Video computer boards
- Voltage regulation circuit
- Communication device
- Image computer boards
- Weighing systems
- High input resistance broadband
- Band-stop filter
