OPA4374AIPWTG4 Overview
In the package, you will find a TSSOP-case to contain the op amp ic. The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. A Tape and Reel case is used for delivering the op amp. During the past two weeks, there have been close to 14 terminations. A total of 14 pins are located on this board. This linear amplifier should be powered by an 5V battery. This particular linear amplifier is a type of Operational Amplifier device, to be precise. The op amp ic has an array of 14 pins on it. Op amp rates 5mV as input offset voltage. Using an 585μA supply current, this operational amplifier ics can be operated. You should keep the voltage gain at 110dB for the time being. To operate this buffer amplifier, the temperature must not be lower than -40°C. A temperature greater than 125°C should not be used for the operation of buffer amplifier. 4 elements make up the design of this buffer amplifier. This electric component can work from a voltage of under 5.5V as far as supply voltage is concerned. A voltage of 2.7V or higher is recommended for the linear amplifier's supply voltage.
OPA4374AIPWTG4 Features
14 Pins
supply voltage of 5V
110dB voltage gain
OPA4374AIPWTG4 Applications
There are a lot of Texas Instruments
OPA4374AIPWTG4 Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
