OPA2703UA Overview
Packaged in a 8-SOIC (0.154, 3.90mm Width) case, the buffer op amp is ready to use. This is a General Purpose type op amp. The op amp is delivered to you in a Tube case. It is estimated that there will be 8 terminations in the next few months. There are a total of 8 pins on this op amp. As a reminder, this buffer op amp should be powered by 5V battery and that the battery should be inserted in the amplifier. A type of Operational Amplifier op amp ic can be identified by the fact that this is a type of Operational Amplifier device. There are 8 pins on this chip. The input offset voltage is 750μV. This electronic component is recommended to be mounted using the mounting type Surface Mount. According to the manufacturer, this buffer op amp works well at -40°C~85°C , which is a good operating temperature. An 160μA volt supply current is needed for this linear amplifier to operate. Maintain 120dB as the voltage gain. As far as the device is concerned, buffer amplifier has 2 channels. One of the advantages of this op amp is that it outputs Rail-to-Rail signals, which is one of its many advantages. The operating supply voltage of the buffer op amp is rated at 6V.
OPA2703UA Features
8 Pins
supply voltage of 5V
120dB voltage gain
Output Type: Rail-to-Rail
OPA2703UA Applications
There are a lot of Texas Instruments OPA2703UA Instrumentational OP Amps applications.
- Oscilloscopes
- Tablets
- Band-stop filter
- Vehicle electronics
- Fission chambers
- single/dual op amp sum and difference circuits
- Television
- Subtraction operation circuits
- Logarithmic operation circuits
- Scintillation detectors
