OPA2614IDRG4 Overview
In the package, you will find a SOIC-case to contain the op amp ic. The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. A Tape and Reel case is used for delivering the op amp. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. This linear amplifier should be powered by an 6V battery. This particular linear amplifier is a type of Operational Amplifier device, to be precise. The op amp ic has an array of 8 pins on it. Op amp rates 1mV as input offset voltage. Using an 12mA supply current, this operational amplifier ics can be operated. You should keep the voltage gain at 95dB for the time being. To operate this buffer amplifier, the temperature must not be lower than -40°C. A temperature greater than 85°C should not be used for the operation of buffer amplifier. 2 elements make up the design of this buffer amplifier. The operating supply voltage of the buffer op amp is rated at 12V. This electric component can work from a voltage of under 12V as far as supply voltage is concerned. A voltage of 5V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 6.3V volts when you conduct this part.
OPA2614IDRG4 Features
8 Pins
supply voltage of 6V
95dB voltage gain
OPA2614IDRG4 Applications
There are a lot of Texas Instruments
OPA2614IDRG4 Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
