OPA170AID Overview
There is a 8-SOIC (0.154, 3.90mm Width) case in which the instrumentation amplifier is packaged. A General Purpose-type buffer amplifier is shown here. As far as the packaging is concerned, buffer op amp is delivered in a Bulk case. It is estimated that there will be 8 terminations in the next few months. In total, there are 8 pins on this op amp ic. It would be helpful if you could remember that this op amp ic should be powered by an 18V battery. Instrumentation amplifier is a part of Operational Amplifier. 8 pins are located on the operational amplifiers. Op amp ic rates 1.8mV for input offset voltage. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. It is recommended that this op amp ic be operated at a temperature no higher than -40°C~125°C for optimal performance. Operational amplifier can operate supply current at 110μA. Maintain 130dB as the voltage gain. There are 1 channels on the operational amplifiers. One of the advantages of this op amp is that it outputs Rail-to-Rail signals, which is one of its many advantages. The operating supply voltage of the buffer op amp is rated at 18V.
OPA170AID Features
8 Pins
supply voltage of 18V
130dB voltage gain
Output Type: Rail-to-Rail
OPA170AID Applications
There are a lot of Texas Instruments OPA170AID Instrumentational OP Amps applications.
- Micro signal measurement
- single/dual op amp sum and difference circuits
- Digital cameras
- Band-stop filter
- Navigation
- Medical imaging
- Multiplication circuits
- High gain DC amplifier
- Comparator
- Inverse/same-phase proportional circuit
