OPA131UA Overview
It is packaged in an 8-SOIC (0.154, 3.90mm Width)-case that protects the operational amplifiers from damage. A General Purpose-type buffer amplifier is shown here. In the case of Tube cases, linear amplifier will be delivered. It is estimated that there will be 8 terminations in the next few months. The pins on this board total to 8 in total. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. It should be noted that this op amp is a type of Operational Amplifier device. The op amp ic has an array of 8 pins on it. With regards to the offset voltage of the input, buffer amplifier is rated at 200μV. This electrical part should be mounted using type Surface Mount. The buffer amplifier functions well at -40°C~85°C as far as operating temperature is concerned. A supply current of 1.5mA can be used to operate this linear amplifier. 110dB should be the voltage gain. On the buffer amps, there are 1 channels that can be used. The operating supply voltage of the buffer op amp is rated at 18V.
OPA131UA Features
8 Pins
supply voltage of 15V
110dB voltage gain
OPA131UA Applications
There are a lot of Texas Instruments OPA131UA Instrumentational OP Amps applications.
- Measurements of Wheatstone bridge
- Wireless base stations
- Polarized electrodes
- Vehicle electronics
- Signal filtering
- Tablets
- Computer workstations
- Voltage regulation circuit
- Multiplication circuits
- Instrumentation
