OPA121KUE4 Overview
A SOIC case is used to package the op amp. OPERATIONAL AMPLIFIER-type instrumentation amplifiers are used in this application. A Rail/Tube case is used to deliver the buffer op amp. The number of terminations is approaching the 8 mark. The total number of pins on linear amplifier is 8. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. In total, the buffer amplifier consists of 8 pins. With regards to the offset voltage of the input, buffer amplifier is rated at 3mV. It is possible to operate this buffer amplifier from a supply current of 2.5mA . 114dB should remain the voltage gain. It is recommended that the temperature of this op amp ic should not fall below 0°C degrees Fahrenheit at any time. No temperature greater than 70°C should be used. As a whole, there are 1 elements that make up this buffer amplifier. The operating supply voltage of instrumentation amplifier is rated 18V voltage. You should conduct this electronic component under the dual supply voltage of 18V.
OPA121KUE4 Features
8 Pins
supply voltage of 15V
114dB voltage gain
OPA121KUE4 Applications
There are a lot of Texas Instruments OPA121KUE4 Instrumentational OP Amps applications.
- RF cable systems
- Signal operation
- Thermocouples
- ECG equipment
- Car stereo
- Measurements of Wheatstone bridge
- Wireless base stations
- Addition operation circuits
- Micro signal measurement
- Proportional counter tubes
