MC3403PWRG4 Overview
Packaged in a TSSOP case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. The op amp is delivered to you in a Tape & Reel case. There is a growing number of terminations approaching the number of 14. The pins on this board total to 14 in total. I would like to remind you that this buffer op amp should be powered by an 15V battery. A total of 14 pins are present on the instrumentation amplifier. There is an input offset voltage of 2mV for this buffer op amp. As long as the supply current of the chip does not exceed 2.8mA, this op amp ic can operate. 106.02dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 4 channels. For the buffer op amp to operate properly, it must be above the temperature of 0°C degrees Celsius. No temperature greater than 70°C should be used. The operating supply voltage of the buffer op amp is rated at 15V. For packing the buffer amplifier, the TAPE AND REEL-axis is adopted. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 30V. A high supply voltage of more than 5V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 15V volts.
MC3403PWRG4 Features
14 Pins
supply voltage of 15V
106.02dB voltage gain
MC3403PWRG4 Applications
There are a lot of Texas Instruments
MC3403PWRG4 Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
