MAX4594DBVR Overview
Shipping overseas is convenient with the electronic component packed in SC-74A, SOT-753. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). It is mounted in the position Surface Mount. There is 1:1 ratio between the number of multiplexers and demultiplexers. Operational temperature extended around -40°C~85°C TA. There are 5 terminations totally. The electronic part delivers high-quality output through its 1 channels. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. There is an electrical component included in the 5 series. A SPST - NO switching circuit is used to build these analog multiplexers. If you are looking for variants of the digital switch, trying search with MAX4594. A 10Ohm internal resistance characterizes this multiplexer. The datasheets for the 5 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. Users shouldn't supply more than 5.5V voltage to the switch device. Analogue multiplexers of the Single supply type that are cost-effective. The lowest voltage the electronic part should receive is 2V. The switch device would be able to operate with 1μA current. The voltage required by this switch device is 2.4V~5.5V, draining from a single voltage supply. When the digital multiplexer is charged above 1μA, damage can occur. 300MHz bandwidths enable data to be transferred.
MAX4594DBVR Features
1 Channels
Switch Circuit: SPST - NO
1μA Supply Current
Bandwidth: 300MHz
MAX4594DBVR Applications
There are a lot of Texas Instruments MAX4594DBVR Analog Switches & Multiplexers ICs applications.
- Avionics test equipment
- Audio signal routing
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Automatic test equipment
- DSUs
- PBX interfaces
- Industrial control systems
- Cross Connects
- Cable Modem
- Remote Powered Equipment
