LT1013MJG Overview
In order to protect the op amps, a CDIP case is used. There are two types of operational amplifiers in this circuit. In the case of Rail/Tube cases, linear amplifier will be delivered. In recent months, the number of terminations has approached 8. It consists of a total of 8 pins in total. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. A type of Operational Amplifier buffer op amp is what this device is specifically, to be more precise. It has 8 pins that make up the linear amplifier. In terms of input offset voltage, operational amplifier rates 450μV. 120dB should remain the voltage gain. Buffer op amp is equipped with 2 channels on the device. It is recommended that the temperature of this op amp ic should not fall below -55°C degrees Fahrenheit at any time. Instrumentation amplifier shouldn't be used above 125°C . When it comes to the voltage from which this electrical part will operate, it can operate at a maximum of less than 44V. It is recommended that you keep the instrumentation amplifier's supply voltage higher than 4V when using it. It is recommended that you conduct this electronic part using the dual supply voltage of 22V.
LT1013MJG Features
8 Pins
supply voltage of 15V
120dB voltage gain
LT1013MJG Applications
There are a lot of Texas Instruments
LT1013MJG Instrumentational OP Amps applications.
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
