LP2904DE4 Overview
Packaged in a SOIC case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 5V battery. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 2mV for this buffer op amp. As long as the supply current of the chip does not exceed 85μA, this op amp ic can operate. 96.9dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 2 channels. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. No temperature greater than 85°C should be used. The operating supply voltage of the buffer op amp is rated at 16V. For packing the buffer amplifier, the TUBE-axis is adopted. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 32V. A high supply voltage of more than 3V is recommended for the instrumentation amplifier's supply voltage. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 16V volts.
LP2904DE4 Features
8 Pins
supply voltage of 5V
96.9dB voltage gain
LP2904DE4 Applications
There are a lot of Texas Instruments
LP2904DE4 Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
