LP2902PWR Overview
There is a 14-TSSOP (0.173, 4.40mm Width) case package that contains the instrumentation amplifiers. An op amp of this type is a General Purpose-type. Linear amplifier is delivered in a Tape & Reel (TR) case. It is estimated that there will be 14 terminations in the next few months. Buffer amplifier has a total of 14 pins. I would like to remind you that this buffer op amp should be powered by an 5V battery. It should be noted that this type of buffer amplifier is exactly what is known as a Operational Amplifier device. 14 pins are located on the operational amplifiers. With regards to the offset voltage of the input, buffer amplifier is rated at 4mV. The mounting type that is recommended for this electrical part is Surface Mount. It is important to note that this linear amplifier works well at a temperature of -40°C~85°C when it comes to operating temperatureAs long as the supply current of the chip does not exceed 85μA, this op amp ic can operate. There should be no change in the voltage gain at 96.9dB. A voltage rating of 4 is indicated for the op amp's operating supply voltage. The operating supply voltage of the buffer op amp is rated at 16V. A TR-shaped amplifier is used to pack the buffer amps.
LP2902PWR Features
14 Pins
supply voltage of 5V
96.9dB voltage gain
LP2902PWR Applications
There are a lot of Texas Instruments LP2902PWR Instrumentational OP Amps applications.
- Thermocouples
- Scintillation detectors
- Exponential operation circuits
- Proportional counter tubes
- Switching amplifier
- Automotive sensors
- Signal amplification
- Cinema or auditorium audio system
- Inverse/same-phase proportional circuit
- High gain DC amplifier
