LP2902DG4 Overview
The linear amplifier is packaged in a SOIC case which makes it easy for the consumer to handle. Op amps are OPERATIONAL AMPLIFIER types of amplifier on the chip. A Rail/Tube case is used to deliver the buffer op amp. It is estimated that there will be 14 terminations in the next few months. The pins on this board total to 14 in total. This linear amplifier should be powered by an 5V battery. Instrumentation amplifier is a part of Operational Amplifier. Linear amplifier includes 14 pins. Op amp rates 4mV as input offset voltage. This op amp can operate from a supply current at 85μA. The voltage gain should stay at 96.9dB. In order for op amp to function properly, the temperature should not be lower than -40°C degrees Celsius. In order to avoid damage to the product, operational amplifiers should only be used at temperatures below 85°C. A voltage rating of 4 is indicated for the op amp's operating supply voltage. The operating supply voltage of the buffer op amp is rated at 16V. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 32V. A voltage of 3V or higher is recommended for the linear amplifier's supply voltage. There should be a dual supply voltage of 16V for you to conduct this electrical part.
LP2902DG4 Features
14 Pins
supply voltage of 5V
96.9dB voltage gain
LP2902DG4 Applications
There are a lot of Texas Instruments LP2902DG4 Instrumentational OP Amps applications.
- Inverse/same-phase proportional circuit
- Differentiator circuits
- Tablets
- Oscilloscopes
- High-frequency data acquisition systems
- Medical imaging
- Medical instruments
- Scintillation detectors
- E-book readers
- Measurements of Wheatstone bridge
