LMV791MKX Overview
Packaged in a TSOT case, the buffer op amp is ready to use. An op amp ic of the OPERATIONAL AMPLIFIER type. The op amp is delivered to you in a Tape & Reel case. There is a growing number of terminations approaching the number of 6. The pins on this board total to 6 in total. I would like to remind you that this buffer op amp should be powered by an 2.5V battery. I would like to specify that this buffer amplifier belongs to the Operational Amplifier-type of devices. A total of 6 pins are present on the instrumentation amplifier. There is an input offset voltage of 1.35mV for this buffer op amp. 110dB should remain the voltage gain. As far as the device is concerned, buffer amplifier has 1 channels. For the buffer op amp to operate properly, it must be above the temperature of -40°C degrees Celsius. No temperature greater than 125°C should be used. In terms of the supply voltage, this electrical part is capable of operating at low voltage levels of under 5.5V. A high supply voltage of more than 1.8V is recommended for the instrumentation amplifier's supply voltage.
LMV791MKX Features
6 Pins
supply voltage of 2.5V
110dB voltage gain
LMV791MKX Applications
There are a lot of Texas Instruments
LMV791MKX Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
