LMV612MM/NOPB Overview
Packaged in a 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) case, the buffer op amp is ready to use. The instrumentation amplifier in this picture is of the General Purpose-type. The op amp is delivered to you in a Tape & Reel (TR) case. During the past two weeks, there have been close to 8 terminations. There are a total of 8 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 2.7V volts. A type of Operational Amplifier op amp ic can be identified by the fact that this is a type of Operational Amplifier device. In total, the buffer amplifier consists of 8 pins. Op amp rates 5.5mV as input offset voltage. Surface Mount is the recommended mounting type of operational amplifiers. In terms of operating temperature, this instrumentation amplifier performs well at a temperature of about -40°C~125°C . This op amp can operate from a supply current at 116μA. There should be no change in the voltage gain at 100dB. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs Rail-to-Rail signals. There are 2 elements in total in this linear amplifier. It is used TR to pack the op amps.
LMV612MM/NOPB Features
8 Pins
supply voltage of 2.7V
100dB voltage gain
Output Type: Rail-to-Rail
LMV612MM/NOPB Applications
There are a lot of Texas Instruments LMV612MM/NOPB Instrumentational OP Amps applications.
- High/low-pass filter circuit
- Medical imaging
- Mobile phone
- Automatic control
- Computer workstations
- Division circuits
- Active probe
- Strain gauges
- Automotive sensors
- Test equipment
