LMV331IDBVTG4 Overview
It is packaged in an SOT-23-case that protects the operational amplifiers from damage. As far as the packaging is concerned, buffer op amp is delivered in a Tape & Reel (TR) case. A total of 5 terminations have been reported in the past few weeks. The pins on this board total to 5 in total. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. It should be noted that this op amp is a type of Comparator device. 5 pins are located on the operational amplifiers. There is an input offset voltage of 7mV for this buffer op amp. There should be no change in the voltage gain. As far as the device is concerned, buffer amplifier has 1 channels. To operate this buffer amplifier, the temperature must not be lower than -40°C. You should not use op amp above 125°C . The operating supply voltage of instrumentation amplifier is rated 5V voltage. To pack the operational amplifier ics, TR is adopted as the packing method. With regard to the supply voltage, this electrical component is capable of working from under 5.5V. A voltage of 2.7V or higher is recommended for the linear amplifier's supply voltage. There is an 150μA quiescent current in linear amplifier.
LMV331IDBVTG4 Features
5 Pins
supply voltage of 5V
93.98dB voltage gain
LMV331IDBVTG4 Applications
There are a lot of Texas Instruments LMV331IDBVTG4 Instrumentational OP Amps applications.
- Addition operation circuits
- RF cable systems
- Power generator
- Differentiator circuits
- Proportional counter tubes
- ECG equipment
- Portable docking station
- Power transmission
- Test and measurement instruments
- Test equipment
