LM3723EM5-4.63/NOPB Overview
As far as the mounting terminals of this voltage supervisor are concerned, it has 5 in total. In terms of packaging, power management follows the Tape & Reel (TR) model. Power management is possible to find a series of 1 functions. It is possible to find on this power management a series of 1 channels. To assist you, this PMIC includes SC-74A, SOT-753 functions. Compared to other Simple Reset/Power-On Reset products, this PMIC has a lot of benefits to offer. As specified in the package specification, the peak reflow temperature of the package is set at 260. In a 5V supply voltage, the power management conducts. A supply voltage of 1 is used to conduct the PMIC chip. The mount is attached to Surface Mount. The power management belongs to the Power Management Circuits subcategory. A total of 5 pins are located on this power management. 5 pins are on the supervisor. Normally, the supply voltage (Vsup) for this PMIC should not be lower than 1V. Voltage (Vsup) shouldn't exceed 5.5V volts in this PMIC. The recommended mounting type for IC management is Surface Mount. It is recommended that the supervisor be set to this temperature: -40°C~125°C TA. As a result of this supervisor's operation, the output voltage is Push-Pull, Totem Pole. To find similar IC managements from the manufacturer, you can always search by LM3723. To operate this power management, you will need at least 5V volts of power.
LM3723EM5-4.63/NOPB Features
Simple Reset/Power-On Reset type
Minimum supply voltage of 1V
LM3723EM5-4.63/NOPB Applications
There are a lot of Texas Instruments LM3723EM5-4.63/NOPB Voltage Supervisors applications.
- Medical-specific insulation monitor
- Household appliances
- Fire equipment power monitoring system
- Insulation fault location system
- Important electronics for automotive protection
- Dash board
- Leakage current detection
- DSP
- Power distribution systems of operating room
- Kitchen appliances
