LM158J Overview
It is packaged in an 8-CDIP (0.300, 7.62mm)-case that protects the operational amplifiers from damage. A General Purpose-type buffer amplifier is shown here. Instrumentation amplifier is delivered in a Tube case. It is estimated that there will be 8 terminations in the next few months. The pins on this board total to 8 in total. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. A type of Operational Amplifier buffer op amp is what this device is specifically, to be more precise. A total of 8 pins are present on the instrumentation amplifier. There is an input offset voltage of 2mV for this buffer op amp. For this electrical component, the recommended mounting type is Through Hole, which is the most common. The buffer amplifier functions well at -55°C~125°C as far as operating temperature is concerned. As long as the supply current of the chip does not exceed 1mA, this op amp ic can operate. It is a member of the 100dB's 100dB family. The op amp ic has 2 channels on it. The operating supply voltage of instrumentation amplifier is rated 16V voltage.
LM158J Features
8 Pins
supply voltage of 5V
100dB voltage gain
LM158J Applications
There are a lot of Texas Instruments LM158J Instrumentational OP Amps applications.
- Gaming industry
- Band-pass filter
- Communication
- Cinema or auditorium audio system
- Biopotential
- Weak signal detection
- Scintillation detectors
- Division circuits
- Displayers for aircraft and air transportation control systems
- ECG equipment
