LM158H/883 Overview
In order to protect the op amps, a TO-99 case is used. There are two types of operational amplifiers in this circuit. In recent months, the number of terminations has approached 8. It consists of a total of 8 pins in total. It would be helpful if you could remember that this op amp ic should be powered by an 5V battery. A type of Operational Amplifier buffer op amp is what this device is specifically, to be more precise. It has 8 pins that make up the linear amplifier. In terms of input offset voltage, operational amplifier rates 5mV. Maintain 93.98dB as the voltage gain. Buffer op amp is equipped with 2 channels on the device. It is recommended that the temperature of this op amp ic should not fall below -55°C degrees Fahrenheit at any time. Linear amplifier shouldn't be used above 125°C degrees. When it comes to the voltage from which this electrical part will operate, it can operate at a maximum of less than 32V. It is recommended that you keep the instrumentation amplifier's supply voltage higher than 3V when using it. It is recommended that you conduct this electronic part using the dual supply voltage of 16V.
LM158H/883 Features
8 Pins
supply voltage of 5V
93.98dB voltage gain
LM158H/883 Applications
There are a lot of Texas Instruments
LM158H/883 Instrumentational OP Amps applications.
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
