LM158AHRLQMLV Overview
In the package, you will find a TO-99-8-case to contain the op amp ic. The instrumentation amplifier in this picture is of the OPERATIONAL AMPLIFIER-type. During the past two weeks, there have been close to 8 terminations. A total of 8 pins are located on this board. This linear amplifier should be powered by an 5V battery. This particular linear amplifier is a type of Operational Amplifier device, to be precise. The op amp ic has an array of 8 pins on it. Op amp rates 2mV as input offset voltage. You should keep the voltage gain at 93.98dB for the time being. On the buffer amps, there are 2 channels that can be used. To operate this buffer amplifier, the temperature must not be lower than -55°C. A temperature greater than 125°C should not be used for the operation of buffer amplifier. The operating supply voltage of the buffer op amp is rated at 16V. This electric component can work from a voltage of under 32V as far as supply voltage is concerned. A voltage of 3V or higher is recommended for the linear amplifier's supply voltage. This electrical part should be conducted under the dual supply voltage of 16V volts when you conduct this part.
LM158AHRLQMLV Features
8 Pins
supply voltage of 5V
93.98dB voltage gain
LM158AHRLQMLV Applications
There are a lot of Texas Instruments
LM158AHRLQMLV Instrumentational OP Amps applications.
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
- Signal amplification
- Signal filtering
- Signal operation
- Video computer boards
