LF347BD Overview
In the package, you will find a 14-SOIC (0.154, 3.90mm Width)-case to contain the op amp ic. J-FET-type instrumentation amplifiers are used in this application. The op amp is delivered to you in a Tube case. The number of terminations approaches 14. A total of 14 pins are attached to buffer op amp. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. There are two types of Operational Amplifier op amps in this case, and this device falls into one of them. 14 pins are located on the operational amplifiers. There is an input offset voltage of 5mV for this buffer op amp. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. Regarding the operating temperature of this device, instrumentation amplifier performs well at a temperature of 0°C~70°C . An 8mA volt supply current is needed for this linear amplifier to operate. Voltage gain should remain at 100dB. On the buffer amps, there are 4 channels that can be used.
LF347BD Features
14 Pins
supply voltage of 15V
100dB voltage gain
LF347BD Applications
There are a lot of Texas Instruments LF347BD Instrumentational OP Amps applications.
- Radiation thermometry transducers
- Vehicle electronics
- Voltage regulation circuit
- Multimedia playback equipment
- Band-pass filter
- Instrumentation
- Test and measurement instruments
- Mobile phone
- Micro signal measurement
- Division circuits
