LF198H/883 Overview
Packaged in a TO-99 case, the buffer op amp is ready to use. An op amp ic of the SAMPLE AND HOLD CIRCUIT type. There is a growing number of terminations approaching the number of 8. The pins on this board total to 8 in total. I would like to remind you that this buffer op amp should be powered by an 15V battery. A total of 8 pins are present on the instrumentation amplifier. For the buffer op amp to operate properly, it must be above the temperature of -55°C degrees Celsius. No temperature greater than 125°C should be used. The operating supply voltage of the buffer op amp is rated at 15V. As a rule of thumb, you should conduct this electronic part under a dual voltage supply of 18V volts.
LF198H/883 Features
8 Pins
supply voltage of 15V
LF198H/883 Applications
There are a lot of Texas Instruments
LF198H/883 Instrumentational OP Amps applications.
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
- Power control
- Information processing
- Weak signal detection
