JM38510/11005BCA Overview
A CDIP case is used to package the op amp. OPERATIONAL AMPLIFIER-type instrumentation amplifiers are used in this application. It is estimated that there will be 14 terminations in the next few months. There are a total of 14 pins on this op amp. It is important to remember that this op amp should be operated at a voltage of 5V volts. It should be noted that this op amp is a type of Operational Amplifier device. There are 14 pins on this chip. In terms of the input offset voltage, instrumentation amplifier rates at 5mV. There should be no change in the voltage gain. There are 4 channels on the operational amplifiers. In order for op amp to function properly, the temperature should not be lower than -55°C degrees Celsius. Instrumentation amplifier should only be used at temperatures up to 125°C. I would like to point out that this electrical component is capable of working from a voltage below 32V as far as the power supply is concerned. As a general rule, it is advisable to keep the op amp's supply voltage above 3V at all times. The dual supply voltage of 16V should be used for the conduct of this electronic component.
JM38510/11005BCA Features
14 Pins
supply voltage of 5V
100dB voltage gain
JM38510/11005BCA Applications
There are a lot of Texas Instruments
JM38510/11005BCA Instrumentational OP Amps applications.
- Addition operation circuits
- Subtraction operation circuits
- single/dual op amp sum and difference circuits
- Integrator circuits
- Differentiator circuits
- Logarithmic operation circuits
- Exponential operation circuits
- Multiplication circuits
- Division circuits
- Precision measurement
