INA118UB Overview
Packaged in a 8-SOIC (0.154, 3.90mm Width) case, the buffer op amp is ready to use. There are two types of operational amplifiers in this circuit. The op amp is delivered to you in a Tube case. It is estimated that there will be at least 8 terminations this year. A total of 8 pins are attached to buffer op amp. It would be helpful if you could remember that this op amp ic should be powered by an 15V battery. It has 8 pins that make up the linear amplifier. Regarding input offset voltage, op amp rates 50μV. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. According to the manufacturer, this buffer op amp works well at -40°C~85°C , which is a good operating temperature. As long as the supply current of the chip does not exceed 350μA, this op amp ic can operate. Keeping the voltage gain at 80dB is the best course of action. As far as the device is concerned, buffer amplifier has 1 channels. The op amp is rated for an operating supply voltage of 3. The operating supply voltage of the buffer op amp is rated at 36V. The quiescent current is 350μA. Instrumentation amplifier resistance should remain within the range of 10GOhm.
INA118UB Features
8 Pins
supply voltage of 15V
80dB voltage gain
Resistance of 10GOhm
INA118UB Applications
There are a lot of Texas Instruments INA118UB Instrumentational OP Amps applications.
- Test equipment
- High-frequency data acquisition systems
- Displayers for aircraft and air transportation control systems
- Signal operation
- RF cable systems
- Car stereo
- Band-stop filter
- Ultrasound transducers
- Polarized electrodes
- Weak signal detection
