INA111AU/1K Overview
A 16-SOIC (0.295, 7.50mm Width) case is used to package the op amp. An op amp of this type is a Instrumentation-type. In the case of Tape & Reel (TR) cases, linear amplifier will be delivered. There is a growing number of terminations approaching the number of 16. In this case, there are 16 pins on the board. Please take in mind that this instrumentation amplifier should be run at 15V. An 16-pin op amp ic is included in the package. Op amp ic rates 1mV for input offset voltage. For this electrical component, the recommended mounting type is Surface Mount, which is the most common. It is important to note that this linear amplifier works well at a temperature of -40°C~85°C when it comes to operating temperatureThe voltage gain should stay at 80dB. The buffer amp consists of 1 circuits in total. A total of 3 elements are present in this linear amplifier. The instrumentation amplifier is packed in the form of TR. 3.3mA quiescent currents are flowing through buffer op amp. 10 TΩ is the range in which the op amp resistance should lie.
INA111AU/1K Features
16 Pins
supply voltage of 15V
80dB voltage gain
Resistance of 10 TΩ
INA111AU/1K Applications
There are a lot of Texas Instruments INA111AU/1K Instrumentational OP Amps applications.
- Ultrasound transducers
- Inverse/same-phase proportional circuit
- Differentiator circuits
- Automotive sensors
- Micro signal measurement
- Multiplication circuits
- Band-stop filter
- Weak signal detection
- Power generator
- Exponential operation circuits
