CY74FCT2374TSOCTE4 Overview
The package is in the form of 20-SOIC (0.295, 7.50mm Width). A package named Tape & Reel (TR)includes it. This output is configured with Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. The electronic part is mounted in the way of Surface Mount. A supply voltage of 4.75V~5.25V is required for operation. In this case, the operating temperature is -40°C~85°C TA. A flip flop of this type is classified as a D-Type. FPGAs belonging to the 74FCTseries contain this type of chip. Its output frequency should not exceed 250MHz. In total, it contains 1 elements. There is 200μA quiescent consumption. Currently, there are 20 terminations. This D latch belongs to the family of 74FCT2374. Power is provided by a 5V supply. Its input capacitance is 5pF farads. The electronic device belongs to the FCTfamily. This electronic part is mounted in the way of Surface Mount. A total of 20pins are provided on this board. There is a clock edge trigger type of Positive Edgeon this device. The part is included in FF/Latches. 8bits are used in its design. 5.25Vis the maximum supply voltage (Vsup). The supply voltage (Vsup) should be maintained above 4.75V for normal operation. As a result of its reliability, this D flip flop is ideally suited for TAPE AND REEL. The D latch operates on 5V volts. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. There are no output lines on the JK flip flop. The number of input lines is 8.
CY74FCT2374TSOCTE4 Features
Tape & Reel (TR) package
74FCT series
20 pins
8 Bits
5V power supplies
CY74FCT2374TSOCTE4 Applications
There are a lot of Texas Instruments CY74FCT2374TSOCTE4 Flip Flops applications.
- Digital electronics systems
- ESD performance
- Latch
- Frequency division
- Data storage
- Single Down Count-Control Line
- Asynchronous counter
- Computers
- Test & Measurement
- Storage Registers
