CY74FCT2373TQCTG4 Overview
There is an embedded version of it in package 20-SSOP (0.154, 3.90mm Width). A package of Tape & Reel (TR) has been used. In its configuration, Tri-State is used as the output. The Logic type of this electrical device is D-Type Transparent Latch. A Surface Mount mount is used for mounting this electronic part. In order for it to operate, it needs a supply voltage of 4.75V~5.25V. The operating temperature is -40°C~85°C. In the 74FCT series, this FPGA is located. The design of this electronic part contains 8 bits. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. 74FCT2373 is its family. The supply voltage of the device is 5V. 20 pins are included. It is a member of the FCT family of electronic devices. This board has 20 pins on it, which is what it is designed for. Surface Mount is the way in which this electronic part is mounted. This device has 2 ports on board, which are all available at the same time. FF/Latches is the subcategory of this part. It reaches a maximum supply voltage (Vsup) of 5.25V. There are 5V power supplies attached to it. There should be a voltage supply (Vsup) greater than 4.75V. There are 8 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply. The device's reliable performance makes it a good choice for TAPE AND REEL. The current consumed by the device is 100μA volts in quiescent mode, which cannot be affected by external factors.
CY74FCT2373TQCTG4 Features
20-SSOP (0.154, 3.90mm Width) package
74FCT series
8 Bits
74FCT2373 family
20 pin count
20 pins
5V power supplies
CY74FCT2373TQCTG4 Applications
There are a lot of Texas Instruments CY74FCT2373TQCTG4 Latches applications.
- Shift right with parallel loading
- BCD counting
- Network Switches
- PCs and Notebooks
- Buffer/Storage Registers
- Pseudo-random code generators
- Frequency dividing
- Hammer
- Display driver
- Serial Input
