CD74HCT574M Overview
It is packaged in the way of 20-SOIC (0.295, 7.50mm Width). There is an embedded version in the package Tube. This output is configured with Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. Surface Mountis in the way of this electric part. The JK flip flop operates at 4.5V~5.5Vvolts. It is at -55°C~125°C TAdegrees Celsius that the system is operating. A flip flop of this type is classified as a D-Type. This type of FPGA is a part of the 74HCT series. Its output frequency should not exceed 60MHz. A total of 1elements are contained within it. There have been 20 terminations. If you search by 74HCT574, you will find similar parts. An input voltage of 5Vpowers the D latch. Input capacitance of this device is 10pF farads. It is a member of the HCTfamily of D flip flop. It is mounted by the way of Surface Mount. Basically, it is designed with a set of 20 pins. In this device, the clock edge trigger type is Positive Edge. The part you are looking for is included in Bus Driver/Transceiver. It is designed with 8bits. Its flexibility is enhanced by 8 circuits. The D latch runs on a voltage of 5V volts. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. It is recommended that the supply voltage be kept at 5Vto maximize efficiency. As a result of its output current of 6mA, it is very flexible in terms of design. In order to operate, the chip has 3 output lines. In terms of quiescent current, it consumes 8μA .
CD74HCT574M Features
Tube package
74HCT series
20 pins
8 Bits
5V power supplies
CD74HCT574M Applications
There are a lot of Texas Instruments CD74HCT574M Flip Flops applications.
- Buffer registers
- Single Down Count-Control Line
- Cold spare funcion
- ESD protection
- Memory
- Set-reset capability
- CMOS Process
- QML qualified product
- Synchronous counter
- Counters
